GCode generator - wrong outline

Verified.

Looks like the proximity of the outline to the board edge may be the first problem here, but also, there is some strange offsetting between the arc and line segments.

I looked at the gcode exporter code. And the only problem is that exporter takes the smallest posssible rectange for outline. there is no PNG curve tracing implemented.

Hi,

I just tested your example file and compared my gernerated gcode output with the provided gcode output (it's all in the zipfile).

Attached diff shows that in git HEAD 819db34a1482c9d5b08a9859ff0cf798eaa79cf3 the correct outline dimensions are generated.

Regarding the non-rectangular outline not reflected by gcode output, this needs to be implemented as is stated in the source code (gcode.c:1037):

    /*
     * Currently this is a rather simple implementation, which mills
     * the rectangular extents of the board and nothing else. This should
     * be sufficient for many use cases.
     *
     * A better implementation would have to group the lines and polygons
     * on the outline layer by outer polygon and inner holes, then offset
     * all of them to the right side and mill that.
     */
    /* a better implementation might look like this:
    LAYER_TYPE_LOOP (PCB->Data, max_copper_layer, LT_OUTLINE);
      {
        LINE_LOOP (layer);
          {
            ... calculate the offset for all lines and polygons of this layer,
            mirror it if is_bottom, then mill it ...
          }
        END_LOOP;
      }
    END_LOOP;