Mash wizard does not adjust sparge water temperature for changes in mash temperature
Bug #1670587 reported by
gkornelson
This bug affects 1 person
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
Brewtarget |
New
|
Undecided
|
Unassigned |
Bug Description
Using brewtarget 2.3.0 on Ubuntu:
I create a mash-in step, set a target temperature, and then run the mash wizard and it spits out strike water volume and temperature for that target, and a volume and temperature for the batch sparge step.
If I change the target temperature of the mash and re-run the mash wizard, it adjusts the initial strike water temperature, however does not change anything in the batch sparge step. I get the same behavior if I remove all mash steps and start over, using a different mash target temp. It will spit out the same batch sparge volume and water temperature no matter what temperature my mash is at.
To post a comment you must log in.
Thanks for the report, but we've decamped to github (https:/ /github. com/Brewtarget/ brewtarget/ issues). I will reopen the ticket there tonight and look into this.